Camera Mounting - Novus NVIP-4VE-6502M/F Benutzerhandbuch

NVIP-4VE-6502M/F - User's manual (short form) ver 1.1
START-UP AND INITIAL CAMERA CONFIGURATION

2.3. Camera mounting

To mount a camera please follow the instructions below:
•
Unscrew the counter screw (4).
•
Remove the camera cover (3), remove the camera from the base (5).
•
Put the bracket to the wall in a desired mounting place (with cable hole). Take the drill pattern
and mark future drilling holes for screws and wires.
•
Drill holes for screws, wires and base.
•
Mount the camera base (5) using the supplied plugs and screws.
•
If necessary, unscrew the camera service panel (1), mount microSD card in the socket (2) and
screw the camera service panel (1).
•
Connect the camera wires, put camera on the base (5), attach the cover (3) and pre-tighten the
counter screw (4).
•
Adjust camera position.
•
Tighten to the stop counter screw (4).
CAUTION!
Please note that the wall or ceiling must have enough strength to carry the IP Camera.
CAUTION!
In order to obtain declared degree of protection please seal the camera bracket to prevent water
getting inside. Furthermore, when installing the bracket on rough/uneven surfaces, please
additionally seal the junction with appropriate sealing mass. Please pay special attention to any
mounting holes and if they are a loop-through ones, seal them too.
1
All rights reserved © AAT SYSTEMY BEZPIECZEŃSTWA sp. z o.o.
2
3
4
5
10