Starting The Ip Camera - Novus NVIP-4VE-6502M/F Benutzerhandbuch

NVIP-4VE-6502M/F - User's manual (short form) ver 1.1

2.4. Starting the IP camera

To run NOVUS IP camera you have to connect ethernet cable between camera and network PoE switch
with PoE support (IEEE 802.3af).
You can also power it from 12VDC power supply compatible with camera power supply specification.
After connecting power status red LED should light on. Initialization process takes about 2 minutes.
Then you can connect to the camera via web browser.
The recommended way to start an IP camera and perform its configuration is a direct connection to the
network switch which is not connected to other devices. To obtain further information about network
configuration parameters (IP address, gateway, network mask, etc.) please contact your network
administrator.
•
Connection using network switch with PoE support
IP Camera
Power supply and
network transmission
•
Connection using external power supply and network switch
IP Camera
Network transmission
START-UP AND INITIAL CAMERA CONFIGURATION
Network PoE Switch
Network Switch
All rights reserved © AAT SYSTEMY BEZPIECZEŃSTWA sp. z o.o.
Network transmission
Network transmission
11
Computer
Computer