Samsung SNC-B5368 Kurzanleitung Seite 4

Inside

SNC-B5368-ENG-QG.indd 4
Item
Consists of two different ports:
- ALARM IN : Used to receive the alarm input signal.
Alarm I/O Port
- ALARM OUT : Used to output the alarm output signal.
- GND : Used for earth-grounding.
Restores all camera settings to the factory default. Press and hold it for about 3
seconds to turn off the system indicator and restart the system.
Reset Button
J After resetting the camera, you must run the IP Installer program to change
the basic network settings such as IP address, Subnet mask, Gateway, etc.,
before you can connect to the network.
Description
2009-08-19 오후 8:42: