Polar G Serie Bedienungsanleitung Seite 3

CK640 Blast Chiller / Freezer: Quick Start Guide
Control panel
Timed
Chilling LED
Set-Temperature
Chilling LED
Storage LED
Set-Temperature Positive Blast Chilling And Storage Cycle
To Set and Start Cycle:
• Make sure unit is in "standby" mode. The temperature of unit will flash in standby mode. If still
in cycle mode, please press the set button
• Once in "Standby" mode, press
LED on the left hand side of the controller is flashing.
• Press the set button
• To adjust the temperature, press and hold
• Press the set button
light will start flashing once the set button is pressed.
Please be aware, if previous cycle was a negative, a positive cycle will not run until unit
is back up to temperature.
Set-Temperature Negative Chilling And Storage Cycle
To Set and Start Cycle:
• Make sure unit is in "standby" mode. The temperature of unit will flash in standby mode. If still
in cycle mode, please press the set button
• Once in "Standby" mode, press
LED on the left hand side of the controller is flashing.
• Press the set button
• To adjust the temperature, press and hold
• Press the set button
light will start flashing once the set button is pressed.
CK640_ML_A5_v4_20200728.indb 3 CK640_ML_A5_v4_20200728.indb 3
Alarm LED Minute LED
for 2 seconds to clear.
three times to select "PoS" and ensure the
to show the pre-set temperature. (r3 parameter)
to reduce or
to start the cycle. The cycle will take 2 minutes to start. The probe
for 2 seconds to clear.
four times to select "nEG" and ensure the
to show the pre-set temperature. (r4 parameter)
to reduce or
to start the cycle. The cycle will take 2 minutes to start. The probe
Degree
Celsius LED
Degree
Fahrenheit LED
(probe)
to increase.
(probe)
to increase.
2020/7/28 17:38 2020/7/28 17:38