Polar G Serie Bedienungsanleitung Seite 13

During storage: •
•
•
•
To interrupt the
•
cycle:
Test To Check Correct Pin Probe Insertion
• Set-temperature cycles are preceded by a test step in order to check correct
pin probe insertion.
• If power is interrupted during the test, when power is restored, the test will
start again from the beginning.
The test has two stages:
• if the outcome of the first stage is positive, the second will not be run
• if the outcome of the first stage is negative, the second will be run.
• The outcome of the first stage is positive if "the temperature measured by the pin probe - the
temperature of the cabinet" is greater than the value set by parameter rc at least 3 times out of 5 (the
comparison is made every 10 s); if parameter rc is set to 0, neither the first nor second stages will be
run.
• The outcome of the second stage is positive if the difference "temperature measured by the pin probe
- temperature of the cabinet" is greater by at least 1ºC/1ºF (with respect to the previous comparison)
at least 6 times out of 8 (the comparison is made every "rd/8 s")
If the outcome of the test is positive:
• the cycle will be activated
• the cycle will be started in timed mode
• the LED will flash
Setting The Configuration Parameters
The parameters are arranged on two levels.
To access the first
•
level:
•
To access the •
second level:
•
•
•
•
•
CK640_ML_A5_v4_20200728.indb 13 CK640_ML_A5_v4_20200728.indb 13
the display shows the cabinet temperature
if chilling had a positive outcome, the LEDs
chilling had a negative outcome, the LEDs
LED will flash.
the parameter rA sets the operational set point
press several times to:
- display the message "nEg"
- exit the procedure, or leave for 15 seconds
press for 2 seconds
ensure the device is in "stand-by" mode and no procedures are running
press and for 4 s: the display will show "PA"
access the first level
press or to select "PA"
press
press or within 15 s to set "-19"
press or leave for 15 s
press and for 4 s: the display will show "CA1"
UK
and will be on; if
and will be on and the
13
2020/7/28 17:38 2020/7/28 17:38