Declerations / Deklarationen; Federal Communication Commission Interference Statement - Sigma EOX REMOTE 500 Technische Dokumentation

2.8. Declerations / Deklarationen

CE
Declaration of Conformity
We, SIGMA-ELEKTRO GmbH, declare that the equipment has been tested in our facility and found compliance
with the requirement limits of applicable standards, in accordance with the RED Directive 2014/53/EU and the ROHS
Directive 2011/65/EU and additional according to Directive (EU) 2015/883 to ament Annex II of the above mention
Directive with 4 additional substances. The test record, data evaluation and Equipment Under Test (EUT) configurations
represented herein are true and accurate under the standards herein specified.
You can find the CE declaration at: ce.sigmasport.com/eoxremote500
Federal Communication Commission
Interference Statement
FCC: M5LR500T
Caution: If any changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
The grantee is not responsible for any changes or modifications not expressly approved by the party responsible
for compliance. Such modifications could void the user's authority to operate the equipment.
The RF Exposure Compliance distance is 5 millimeters.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
− Reorient or relocate the receiving antenna.
− Increase the separation between the equipment and receiver.
− Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
− Consult the dealer or an experienced radio/TV technician for help.