Devolo Mesh WiFi 2 Handbuch Seite 75

LED Flashing
haviour
3 Red LED Lights up stea-
dy
4 Red and Flashes at in-
white tervals of 0.1
LED sec. red/2 sec.
white
be- Meaning
Status 1:
The other network nodes are in standby
mode and cannot currently be accessed over
the mains supply. The PLC LEDs of the other
devolo Mesh adapters flash white only for a
short time.
Status 2:
The connection to the other network nodes
has been interrupted. There may be electro-
magnetic or radio frequency interference on
the power line. In this case, put the
devolo Mesh adapters closer to each other
or try to shut off the source of interference.
Data transmission rate not in optimum
range **
Introduction 19
LED status display
(web interface*)
Can be disabled
Can be disabled
devolo Mesh WiFi 2