Werbung
Verfügbare Sprachen
Verfügbare Sprachen
The loudspeaker outputs of the mixer/amplifier are 4 Ohms, 8 Ohms, 70V and 100V. C C o o n n n n e e c c t t t t h h e e
M M M M A A 8 8 3 3 5 5 2 2 ( ( 1 1 2 2 0 0 V V ) )
l l o o u u d d s s p p e e a a k k e e r r s s y y s s t t e e m m t t o o a a n n y y O O N N E E o o f f t t h h e e s s e e o o u u t t p p u u t t s s . . Class 2 wiring may be used.
There are two types of output: 4 Ohm Direct Output;
8 Ohm, 70V, and 100V via Output Transformer
The method of connection differs in each case. Refer to F F i i g g u u r r e e 7 7 . If using the transformer
isolated outputs be sure that the Low Cut switch is ON.
Note: Impedance values shown in Figure 7 indicate total loudspeaker system (load) impedance.
Figure 7
12
Werbung
