Klarstein Grandbreeze Eco 12K Bedienungsanleitung Seite 42

EN
42
Changing the temperature unit
When the device is in operation, press and hold the remote control button to change the
temperature unit or press and hold (+) and (-) buttons simultaneously for 3 seconds to
change the temperature unit. Before the change is made, the display will show as shown
in figure 1. After the change, the display is shown as shown in figure 2.
1
Swing function (only by remote control)
This function allows you to swing the air guide lamella up and down so that the air is
better distributed in the room. First select the desired mode (Cool, Dry or Fan) and then
press the swing function button on the remote control. Press the button again to stop the
swing function.
Sleep function (only via remote control)
This function is suitable for falling asleep as it continuously reduces the operation of
the device. The function keeps the room at an optimal temperature without excessive
temperature or humidity fluctuations during silent operation. The fan speed is reduced
to the lowest speed while the room temperature and humidity vary slightly to ensure the
best possible sleeping comfort.
• First select the desired mode (Cool or Heat) and then press the Sleep button on
the remote control. The brightness of the display is reduced and the fan speed is
reduced to the lowest level.
• In Cool mode, the selected temperature increases by 1°C (1°F) per hour for a
period of 2 hours. This new temperature is maintained for the next 6 hours. Then the
device switches off automatically.
• In heating mode, the selected temperature decreases by 1 °C (1 °F) per hour over
a period of 3 hours. This new temperature is maintained for the next 5 hours. Then
the device switches off automatically.
• The sleep function can be cancelled at any time during operation by pressing the
sleep function button, MODE (mode) or FAN SPEED (fan speed).
• In FAN or DRY mode, the sleep function cannot be set.
2