Behringer ULTRA OCTAVER UO300 Bedienungsanleitung

ULTRA OCTAVER UO300
3-Mode Octaver Effects Pedal
(5)
(1)
(2)
(8)
Thank you for showing your confidence in us by purchasing the
Behringer ULTRA OCTAVER UO300. This high-quality effects pedal
creates a monster sound by adding two additional tones using your
guitar—one and two octaves below the original tone. Thanks to its
high-performance features you'll get natural, clear octave sounds with
constant pitch, even for staccato playing.
Octave effect is possible due to a circuitry that generates signals one or
more octaves below the input signal.
1. Controls
The RANGE selector allows you to optimize the effects pedal
(1)
for HIGH, MID and LOW frequencies and use instruments with
different frequency ranges (guitar, bass guitar, keyboard, etc.)
The DIRECT control adjusts the level of the original input signal.
(2)
The OCT 1 control adjusts the level of the generated signal one
(3)
octave below the original signal.
The OCT 2 control adjusts the level of the generated signal two
(4)
octaves below the original signal.
The blue ON/BATT LED illuminates when the effect is activated.
(5)
It also serves as a battery level indicator.
Use the footswitch to activate/deactivate the effect.
(6)
Use this ¼" TS IN connector to plug in the instrument cable.
(7)
The ¼" TS OUT connector sends the signal to your amp.
(8)
Use the DC IN connection at the front of the unit to plug in a 9 V power
supply (not included).
The BATTERY COMPARTMENT is located underneath the pedal cover.
To install or replace the 9 V battery, press the hinges with a ballpen and
remove the pedal cover. Be careful not to scratch the unit.
V1.0
A50-00002-85282
(4)
(3)
(7)
(6)