Behringer NOISE REDUCER NR300 Bedienungsanleitung

NOISE REDUCER NR300
Ultimate Noise Reduction Effects Pedal
(4)
(1)
(2)
(8)
(9)
Thank you for showing your confidence in us by purchasing the Behringer
NOISE REDUCER NR300. This ultimate effects pedal is specifically designed
to eliminate unwanted noise and hum without altering your tone. Thanks
to its high-performance features it preserves the original attack and
envelope while leaving your playing and dynamics intact.
1. Controls
This MODE switch allows you to chose between MUTE
(1)
and REDUCTION mode. Pressing the pedal in MUTE mode
results in muting the whole input signal, to reduce noises
in during pauses for example. In REDUCTION mode,
quiet passages (when noise or hum would get obvious
to the listener) are effectively reduced. Adjustments
to threshold and decay settings are necessary in this case
(see below).
Use the THRESH(old) control to define a level threshold
(2)
in REDUCTION mode. When the input signal falls below
this value, the unit starts reducing the signal.
The DECAY control determines how fast the signal reduction
(3)
is released when the input signal exceeds the threshold
value again.
The MUTE/BATT LED illuminates when the effect is activated.
(4)
It also serves as a battery level indicator.
The REDUCTION LED illuminates when the input level falls
(5)
below the threshold and starts getting reduced.
Use the footswitch to activate/deactivate the effect.
(6)
Use this 1/4" TS IN connector to plug in the instrument cable.
(7)
V 2.0
(5)
(3)
(7)
(10)
(6)