Behringer ULTRA METAL UM300 Kurzanleitung

ULTRA METAL UM300
Heavy Metal Distortion Effects Pedal
(2)
(1)
(3)
(9)
Thank you for showing your confidence in us by purchasing the
Behringer ULTRA METAL UM300. This high-quality effects pedal comes
with a dual-gain circuitry that enables you to produce super thick, tube-
like distortion plus endless sustain. Thanks to its high-performance
features you will achieve the most extreme and sought-after hard rock
or heavy metal distortion sounds.
1. Controls
The LOW control allows yu to boost/cut the lo-frequency range.
(1)
◊ ◊
Please keep in mind that extrme distortion and EQ
settings will increase nose and may induce oscillation.
The two MID FREQ(uency) controls allow to boost/cut a dè ned
(2)
mid-frequency range. The upper control is used to increase
or lower the mid range, the cntrol below adjusts the center
frequency of the mid range that is affected (200 Hz to 5 kHz).
The LEVEL control adjusts the output level.
(3)
The ON/BATT LED illumnates when the effect is activated. It also
(4)
serves as a battery leve indicator.
Use the footswitch to activate/deactivate the effect.
(5)
Use this ¼" TS IN connector to plug in the instrument cable.
(6)
The ¼" TS OUT connector sends the signal to your amp.
(7)
Use the DC IN connection to plug in a 9 V power supply (not included).
The BATTERY COMPARTMENT is located underneath the pedal cover.
To install or replace the 9 V battery, press the hinges with a ballpen and
remove the pedal cover. Be careful not to scratch the unit.
V1.0
A50-00002-76547
(5)
(4)
(6)
(8)
(7)