Heatscope SmartBox Original Montage- Und Gebrauchsanleitung Seite 44

CoNTRoL VIA SoMFy
SMARTBOX
Additionally to the standard version of the
You can control the HEATSCOPE
straightaway with your somfy
again, that both switches on the heater has been switched on.
Funktionality and connection of your somfy
Choose the favoured channel on your somfy
press the PROGRAM button.
EN
To interconnect your somfy
and the SMARTBOX, connect them again for 8 seconds and disconnect them finally for 3 seconds. After
this you can switch on the power supply regularly.
This is the standard procedure to integrate new somfy
3 to 5 seconds (both LED on the
again.
Now the
SMARTBOX
· Choose the programmed channel of the heater.
· Press UP button shortly:
· Press DOWN button for long:
· Press UP button for long:
· Press DOWN button shortly:
AUTo-oFF FEATURE
The
SMARTBOX
This additional feature switches off the heater after a specific period of time.
As soon as the HEATSCOPE
100% → 50%), the preprogrammed Auto-OFF feature resets to zero. Now the timer function starts again.
Standard: Auto-OFF activated (4h)
To change the standard setting, click the DOWN button of the remote 5x with max. 1 sec. interval right
after connecting the HEATSCOPE
After recognizing this command the blue LED will switch off and the two red LED will start blinking
3x slowly (1sec on, 1sec. off). After this the
actual setup of the Auto-Off feature. The blue LED will not light!
With the help of the UP/DOWN buttons of the remote you can change the setup easily.
To save the desired new setup, just press the ON/OFF button finally.
44
M U N I C H H O M E S Y S T E M S
®
I/o
®
via the somfy
® remote (not included in the scope of delivery). You have to make sure
® remote please disconnect the power supply for 3 seconds from the heater
SMARTBOX
was recognized from the Situo I/O remote control and it can be switched as follows:
the heater will power up at 100%.
the heater will switch down to 50%.
the heater will switch up again to 100%.
the heater will switch off.
is equipped with an Auto-OFF feature (not available with somfy
® heater is regulated via
® and SMARTBOX with the power supply.
SMARTBOX there is also a somfy
®
I/O SMARTBOX (ON/OFF, 50%, 100% power)
®
I/O Situo remote control:
® remote on which you want to program the heater. After this
® modules. The
will light up red) and after max. 5 seconds it will turn off
and IR control unit (50% → 100%,
SMARTBOX
SMARTBOX is in setup mode. The two red LED will show the
® I/O unit available.
will now turn on for
SMARTBOX
® I/O control unit).