Electrolux ERS3DF18S Benutzerinformation Seite 14

14 www.electrolux.com
Problem
The appliance is noisy.
The compressor operates
continually.
The compressor does not
start immediately after
pressing the "FastCool", or
after changing the temper‐
ature.
Door is misaligned or inter‐
feres with ventilation grill.
Door does not open easily. You attempted to re-open
The lamp does not work.
There is too much frost
and ice.
Possible cause
The appliance is not sup‐
ported properly.
Temperature is set incor‐
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed cor‐
rectly.
The FastCool function is
switched on.
The compressor starts af‐
ter a period of time.
The appliance is not level‐
led.
the door immediately after
closing.
The lamp is in stand-by
mode.
The lamp is defective.
The door is not closed cor‐
rectly.
The gasket is deformed or
dirty.
Food products are not
wrapped properly.
Temperature is set incor‐
rectly.
Appliance is fully loaded
and is set to the lowest
temperature.
Solution
Check if the appliance
stands stable.
Refer to "Control Panel"
chapter.
Wait a few hours and then
check the temperature
again.
Refer to "Installation" chap‐
ter.
Allow food products to cool
to room temperature be‐
fore storing.
Refer to "Closing the door"
section.
Refer to "FastCool func‐
tion" section.
This is normal, no error
has occurred.
Refer to installation instruc‐
tions.
Wait a few seconds be‐
tween closing and re-open‐
ing of the door.
Close and open the door.
Contact the nearest Au‐
thorized Service Centre.
Refer to "Closing the door"
section.
Refer to "Closing the door"
section.
Wrap the food products
better.
Refer to "Control Panel"
chapter.
Set a higher temperature.
Refer to "Control Panel"
chapter.