Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3. Do not install carbon monoxide alarms close to fans, windows, etc which could
draw CO away from the alarm.
4. Do not install in high humid environments such as bathrooms, or in areas
where dust or dirt could easily build up and clog the sensor.
5. Do not install near ceiling decorations which could impede the diffusion of CO,
or in places where the detector can easily be touched, damaged or removed.
Installation
This CO alarm is powered by batteries and requires no additional wiring. It can be
installed either on the wall using the fixings provided or on a tabletop.
Wall mount installation
IMPORTANT: Before drilling any wall, make sure there is no electrical wir-
ing or pipe work behind or in the area directly adjacent to the selected
mounting position.
1. Using the mounting plate as a guide, mark the locations of the two mounting
holes.
2. Drill holes in the positions marked using a drill bit.
3. Push the included anchor plugs firmly into the holes.
4. Screw the included screws into the anchor plugs leaving them 4 mm 3/16
inches) proud of the surface.
4
5. Insert the 3 AA 1.5V batteries firmly into the battery compartment on the rear
of the alarm.
6. Aligning the alarm unit with the mounting screws, carefully push the front of
the unit onto the back plate. If the unit does not locate firmly, remove the front
unit, screw in the retaining screws half a turn and try again. For proper installa-
tion, the unit should sit firmly against the back plate.
Tabletop Installation
If installing the CO monitor on a tabletop, ensure that the unit does not lie flat
and prevent clear and easy referral to the LEDs and LCD screen.
Operation
Installing the Batteries
Open the battery compartment on the rear of the detector and insert the three
AA 1.5V batteries (included).
Normal Operation
When no carbon monoxide is detected and to indicate normal operational status,
the green LED flashes once every 50 seconds, the LCD screen displays '0 ppm' and
the 'speaker' symbol,
Testing the Alarm
Press the TEST button. The unit will then trigger an analog output equal to a high
CO concentration. The alarm will sound and the LED will begin flashing red. The
5
Quicklinks ausblenden:
Werbung
Inhaltsverzeichnis
