LENCO Xemio-768 Handbuch Seite 8

Note: Make sure the player power is in "Off" status when insert / remove the
Micro SD memory card from mem ory card slot. Otherwise, the player
functional may result dead halt or the internal data / files will be lost or
damaged.
3. About Player Battery
Player has an internal, non–user-replaceable battery. For best results,
the first time you use player, let it charge for about 3 ~ 4 hours or until the
battery status icon in the "Connect" screen shows that the battery is in full.
Note: Player may continue use battery power after it's been turned off. For
maintain the battery life and performance, if unit isn't used for a while, the
battery need to be recharged, recharging the battery at least once per
month.
Warning: better use the original USB cable delivered with your MP3
player. This cable is a data and charging cable. Some other USB cables in
the market are charging only cables. If you use a charging only cable to
transfer data from your computer to your player, it will only show the
battery symbol on the screen and will not be detected by your computer
as an external drive; this means that you cannot transfer any files from
your computer to your MP3 player.
Note :
The player contains a built-in temperature monitor sensor. If it senses that
the battery pack temperature is not in good condition it will control and
stop the charging function. The charging function will be automatically
restored when the detected battery pack temperature returns to within
normal limits.
a. Charging the Battery:
You can charge the player battery in two ways:
 Connect player to your computer. Or,
 Use the USB power charger. (not included)
b. Connection and Charging:
 Once you have connected player with computer / power charger, then
you will see the "Choose connection" screen appear to choose and it will
switch to Charge & Transfer" mode automatically if no action in 4 ~ 5
seconds.
 Choose "Charge & Transfer" to upload or download the media files with
Battery is full
8