sammic MO-1834 Gebrauchsanweisung Seite 22

EN ES
How to remove and install the oil blockage
Warning: Before remove and install the oil blocka-
ge, be sure to unplug the appliance from the power
supply, and avoid high temperature scald.
1. Hands with oil blockage, pressed on the arrow
shown, pushed back slamly, then pulling down.
2. Status of remove
3. Taking oil blockage from the appliance.
thumb pressed here
1. Hands to take the oil blockage, after alignment
three cylinder of the oil blockage, inserting the
three holes of the back plate.
2. The left hand grasp the microwave, right thumb
to press the arrow directions and forced to push
back. And the left thumb hard pressed upword at
the same time. Put the right of oil blockage into
the buckle of the front plate.
3. From right to left, make the oil blockage loaded.
When finish, check to ensure that the oil blockage
buckle completely go
22
- 22 -
thumb pressed here