Werbung
EN - Assembly instructions for Zolia car pet fence
The dog guard must be assembled as shown on the Diagram 1.
Pack contents :
A . Upper cross bars
B . Lower cross bars
C . Telescopic legs
D . 2 Rubber tops
E . 2 Rubber Feet
F . 8 Phillips screws
G . 2 Washers
Proceed as follow to assemble the dog guard :
❏ Lay our cross bars ( A&B) in front of you.
❏ Slot the telescopic legs ( C ) through the plastic fittings.
❏ Using a Phillips screwdriver, drive the screws supplied into the holes provided in the plastic fittings as illustrated on picture 2
❏ Do not tighten the screws fully at this stage.
❏ Fix the rubber tops to the top of each telescopic leg.
❏ A bolt is located at the end of the telescopic section. Screw out the bolt 2-3cm, put the rubber foot on the bolt like the picture 3
❏ Tip : the rubber foot fits very tightly onto the bolt. You may wish to soften the rubber foot slightly by immersing it in warm water first
5
6
7
Werbung
