Hints And Tips - Viesta I2Z Gebrauchsanleitung

KEN001AKI

Hints and tips

Problem
The induction hob cannot
be turned on
The touch controls are
unresponsive.
The touch controls are
difficult to operate.
The glass is being
scratched.
Some pans make crack-
ling or clicking noises.
The induction hob makes
a low humming noise
when used on
a high heat setting.
Fan noise coming from
the induction hob.
Pans do not become
hot and appears in the
display.
The induction hob or a
cooking zone has turned
itself off unexpectedly, a
tone sounds and an error
code is displayed
(typically alternating with
one or two digits in the
cooking timer display).
[English]
Possible causes
No power.
The controls are locked.
There may be a slight film of water
over the controls or you may be
using the tip of your finger when
touching the controls.
Rough-edged cookware.
Unsuitable, abrasive scourer or
cleaning products being used.
This may be caused by the const-
ruction of your cookware (layers of
different metals vibrating differently).
This is caused by the technology
of induction cooking.
A cooling fan built into your
induction hob has come on to
prevent the electronics from
overheating. It may continue to
run even after you've turned the
induction hob off.
The induction hob cannot detect
the pan because it is not suitable
for induction cooking.
The induction hob cannot detect
the pan because it is too small for
the cooking zone or not properly
centred on it.
Technical fault.
[ 22 ]
What to do
Make sure the induction hob is
connected to the power supply
and that it is switched on.
Check whether there is a power
outage in your home or area.
If you've checked everything and
the problem persists, call a quali-
fied technician.
Unlock the controls. See section.
'Using your induction cooktop' for
instructions.
Make sure the touch control area
is dry and use the ball of your
finger when touching the controls.
Use cookware with flat and smoo-
th bases. See 'Choosing the right
cookware'.
See 'Care and cleaning'.
This is normal for cookware and
does not indicate a fault.
This is normal, but the noise
should quieten down or disappear
completely when you decrease the
heat setting.
This is normal and needs no acti-
on. Do not switch the power to the
induction hob off at the wall while
the fan is running.
Use cookware suitable for inducti-
on cooking. See section 'Choosing
the right cookware'.
Centre the pan and make sure
that its base matches the size of
the cooking zone.
Please note down the error
letters and numbers, switch
the power to the induction hob
off at the wall, and contact a
qualified technician.
18.09.2017 • v09