Fellowes Powershred M-7Cm Bedienungsanleitung Seite 3

BASIC SHREDDING OPERATION
Continuous operation:
NOTE: Shredder runs briefly after
each pass to clear entry.
Continuous operation beyond 5
minutes will trigger a 30-minute
cool down period.
PRODUCT MAINTENANCE
OILING SHREDDER
If not oiled, a machine may experience diminished sheet
capacity, intrusive noise when shredding and could ultimately
oil your shredder each time you empty your waste bin.
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
TROUBLESHOOTING
PAPER JAM
1 2
Set to Reverse Alternate slowly back and forth
(
) for
2-3 seconds
LIMITED PRODUCT WARRANTY
defects in material and workmanship and provides service and support for 1 year from the date of
from defects in material and workmanship for 3 years from the date of purchase by the original
consumer. If any part is found to be defective during the warranty period, your sole and exclusive
warranty does not apply in cases of abuse, mishandling, failure to comply with product usage
standards, shredder operation using an improper power supply (other than listed on the label), or service under this warranty, please contact us or your dealer.
PAPER/CARD
1 2
Set to Auto-On ( )
straight into paper
entry and release
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1
Set to Off ( )
3 4
Set to Off ( )
and unplug
3
When finished shredding
)
2
3
Set to Reverse (
* Apply oil
for 2-3 seconds
across entry
5 6
Set to Auto-On ( )
Gently pull uncut
paper from paper and resume shredding
entry. Plug in
)
3