Sainlogic FT0073 Benutzerhandbuch Seite 26

When complete, press the ALARM button again, and the display will
return to normal mode.
When a temperature or humidity alarm condition has been triggered,
the alarm will sound for 120 seconds, and flash until the temperature or
humidity condition is no longer valid. Press any key to silence the
alarm.
The alarm will reactivate automatically once the value has exceeded
the alarm limit again. To avoid repeated alarms, you should disable the
alarm function or set it to a new value.
5.2.3 Viewing the High and Low Alarms
With the indicator arrow pointing at the indoor or channel 1-3, press
the ALARM button once to view the High alarm, and press the ALARM
button again to view the Low alarm limits at all.
5.3 Reset Max/Min
With the indicator arrow pointing at the appropriate channel, press
the MIN/MAX/- button once to check the MAX values, press and hold
the MIN/MAX/- button for 3 seconds to restore the MAX values to the
current value.
Press the MIN/MAX/- button once again to check the MIN values,
press and hold the MIN/MAX/- button for 3 seconds to restore the MIN
values to the current value.
When complete, press the MIN/MAX/- button again, and the display will
return to normal mode.
5.4 Temperature Units of Measure
The default temperature units of measure are degrees Fahrenheit. To
toggle between degrees Celsius and degrees Fahrenheit, press and
hold the MIN/MAX button for 3 seconds while in normal mode.
5.5 Sensor Search Mode
If any of the sensor communication is lost, dashes (--.-) will be
displayed on the screen. To reacquire the signal:
-26-