Werbung
Verfügbare Sprachen
Verfügbare Sprachen
minutes for all sensors to stabilize. The temperature can be adjusted or
calibrated later to match each other or a known source.
3. Remote Sensor Installation
If you mount one or more of the sensors outside, it is recommended
you mount the sensor(s) on a north facing wall, in a shaded area.
Direct sunlight and radiant heat sources will result in inaccurate
temperature readings. Although the sensors are water resistant, it is
best to mount in a well protected area, such as under an eve. Use a
screw or nail (not included) to affix the remote sensor to the wall, as
shown in Figure 6.
4. Display Features
4.1 Comfort Icon
The comfort icon is based on humidity ranges specified in Figure 7 .
The icon is displayed for indoor humidity, remote channel 1-3 humidity
and optional remote channels 4 through 8 humidity.
RH<45%
Dry
4.2 Rate of Change Icon
The rate of change icon
Figure 6
RH45%~65%
Comfortable
Figure 7
detects rapid changes in temperature.
-23-
RH>65%
Wet
Werbung
