Werbung
Verfügbare Sprachen
Verfügbare Sprachen
9. Repeat for the additional remote transmitters, verifying each
remote is on a different channel.
2.4 Display Console Set Up
1. Move the transmitters(s) about 1 to 3m away from the display
console (if the transmitters are too close, it may not be received by the
display console). With multiple transmitters, make sure all transmitters
are powered up and displaying different channels on the display.
2. Remove the battery door on the back of the display, as shown in
Figure 4. Insert four AAA (alkaline or lithium, avoid rechargeable)
batteries into the back of the display console.
Figure 4
All of the LCD segments will light up for a few seconds to verify all
segments are operating properly.
3. Replace the battery door, and fold out the desk stand and place
the console in the upright position.
The console will instantly display indoor temperature and humidity as
designated by the
icon. The remote temperature and humidity will
update on the display within a few minutes on the appropriate channel.
While in the search mode, the remote search icon
will be constantly
displayed.
If you have more than three remote sensors (additional channels 4-8
are supported), the display will automatically toggle between sensors
until all sensors have reported in.
-21-
Werbung
