Sainlogic FT0073 Benutzerhandbuch Seite 22

Do not touch any buttons until all of the remote sensors have reported
in, or the radio search icon is no longer on, otherwise the remote
sensor search mode will be terminated. When the remote sensors have
been received, the console will automatically switch to the normal
mode, and all further settings can be performed.
If the remotes do not update, please reference the troubleshooting
guide in Section 8.
2.4.1 Display Console Layout
Figure 5
2.4.2 Sensor Operation Verification
Verify the humidity sensors match closely with the console and the
sensors are in the same location (about 1-3 meters apart). The sensors
should agree within 10% (the accuracy is ± 5%). Allow about 30
minutes for all sensors to stabilize. The humidity can be adjusted or
calibrated later to match each other a known source.
Verify the temperature sensors match closely with the console and
sensor array in the same location (about 1-3 meters apart). The
sensors should be within 2°C (the accuracy is ± 1°C). Allow about 30
-22-