Maintenance - Gamma Piu 021 Übersetzung Der Originalanleitung

Fully charge the appliance at least once a year.
To replace the battery refer to the instructions in par. "Battery replacement" (chap.

"MAINTENANCE").

USE
ATTENTION! Do not use the appliance if the blade of head 2 (fig. A) is
damaged or if the blade block is not working correctly.
Do not use the appliance on wet hair.
Gamma Più Professional Clippers are ideal for trimming hair and beard.
The cutting length can be adjusted to ten different heights, from 0.8 mm to 20 mm.
TURNING THE APPLIANCE ON AND OFF
Turning on
• Move switch 14 (fig. A) to the ON position; the LED 13 (fig. A) will light up red.
Turning off
• Move switch 14 (fig. A) to the OFF position; the LED 13 (fig. A) will go out.
USEFUL TIPS FOR CUTTING
• Wash the hair as usual, dry and brush it in the direction of growth to untangle any knots.
• After drying, do not use hairspray, mousse or gel.
• Start at the highest setting of the supplied guide comb (20 mm) and gradually reduce
the setting of the hair length using the other guide combs supplied (12-9-6-3 mm).
• For best results, use the appliance against the direction of hair growth.
• If hair starts to clog the guide comb, remove the guide comb from the appliance (see
par. "Removing the guide comb") and clean away the hair (blow and/or brush out).
USING THE APPLIANCE
Use of the cutting guide comb
To insert the guide comb (fig. A1), follow the instructions below:
• Check that the appliance is off.
• Slide the guide comb onto the head until you hear it click into place (Fig. C).
• Ensure that the guide comb is correctly inserted in the slots on either side.
• Turn on the appliance as indicated in par. "TURNING THE APPLIANCE ON AND OFF. "
• Cut the hair; for tips see par. "USEFUL TIPS FOR CUTTING".
Turn off the appliance before changing or inserting any accessories.
Removing the guide comb
• Turn off the appliance.
• Push the guide comb so that it slides off the appliance (Fig. C1).
Using without the guide comb
When using the appliance without the guide comb, the blade of the
head (2) will cut the hair very close to the skin.
The appliance can be used without the guide comb to cut hair very close to the skin
(0.8 mm) or to redefine the hairline of the neck and around the ears.
If the appliance has been used with the guide comb and is then to be used without it,
remove the comb as described in par. "Removing the guide comb".
Instructions to adjust the cut
The clipper has five adjustable lengths: 0.8/1.1/1.4/1.7/2.0 mm.
Rotate the ring 15 (fig. A) clockwise or anticlockwise (fig. D) until the indicator
reaches the desired height 16 (fig. A). The height can be adjusted from 0.8 mm to 2.0
mm in 0.3 mm steps without using the guide combs.
MAINTENANCE
GENERAL CLEANING
It is recommended to clean daily or after every use.
Always disconnect the power cord from the mains socket before cleaning.
14
When cutting close to the ears, you are advised to use
your hand to protect your ear against injury.