Installation - Antari B-200 Bedienungsanleitung

cord or the remote, leave the machine unplugged until the B-200 is dry.

Installation

Install the bubble machine in a well-ventilated area. Never cover the unit's vents. In order to guarantee
adequate ventilation, allow a free air space of at least 20 cm around the sides and top of the unit. Install the
device out of the public area. Please consider that liquid may be spitted during operation around the device.
The resulting slippery surface can cause accidents. Position output of bubbles away from persons. The
minium distance should be 1.5 m. Only install the machine on scratch resistant and water resistant surfaces.
Please make sure that the inclination angle does not exceed 15° .
When installing the device, make sure there is no highly-inflammable
Material (decoration articles, etc.) within a minimum distance of 0.5 m.
This device is constructed for a standing installation only. If the device is to be installed overhead, the
following safety instructions are binding:
Please consider the EN 60598-2-17and the respective national norms during the installation!
The installation must only be carried out by an authorized dealer!
The installation of the device has to be built and constructed in a way that it can hold 10 times the weight for
1 hour without any harming deformation.
The installation must always be secured with a secondary safety attachment, e.g. an appropriate catch net.
This secondary safety attachment must be constructed in a way that no part of the installation can fall down if
the main attachment fails.
When rigging, derigging or servicing the device staying in the area below the installation place, on bridges,
under high working places and other endangered areas is forbidden.
Washer Washer
M8 Screw
M8 Safety eyelet
DMX DIP SW.
Dip switches
OFF ON
4 5
SW. 1 2 3 6 7 8 9
1 4 2 8 32 16 64 128 256
CH.
DANGER OF FIRE!
DANGER TO LIFE!
3
Washer
Washer
Tightening Screw
Tightening screw