Danger Of Explosion; Unpacking & Inspection - Antari B-200 Bedienungsanleitung

Danger of Explosion

Never add flammable liquids of any kind (such as oil, gas, perfume) to the bubble liquid.
Use only high-quality, water-based liquid that your dealer recommends. Other liquids may cause
clogging or "spitting".
Always make sure there is sufficient liquid in the tank. Operating this unit without liquid will cause
damage to the pump.
If your ANTARI B-200 Bubble Machine fails to work properly, discontinue use immediately. Drain all
liquid from the tank, pack the unit securely (preferably in the original packing material), and return it to
your ANTARI dealer for service.
Always drain tank before mailing or transporting this unit.
Never drink bubble liquid. If it is ingested, call a doctor immediately. If liquid comes in contact with skin or
eyes, rinse thoroughly with water.
Pay attention to all warning labels and instructions printed on the exterior of your
Unpacking & Inspection
Open the shipping carton and verify that all equipment necessary to operate the system has arrived intact.
In addition to this user manual, the shipping carton should contain the following items:
1. B-200 Bubble Machine
2. Power cord and plug
3. 1 Mounting bracket
4. 2 pieces of tightening screws and metal screws, 5 pieces of washers, one safety ring.
If any equipment is missing contact your ANTARI dealer immediately.
Before beginning with the initial setup your Bubble Machine, make sure that there is no evident damage
caused by transportation. In the event that the unit's housing or cable is damaged, do not plug it in and do
not attempt to use it until after contacting your ANTARI dealer for assistance.
Setup
Remove all packing materials from shipping box. Check that all foam and plastic padding is removed,
especially in the nozzle area.
Place the bubble machine on a flat surface.
Loosen the side screws at the front of the B-200 and lift the top of the case up. This will expose the liquid
tray where the bubble liquid is added. Fill the liquid to no more than 3 cm from the top of the tray.
Pour the bubble liquid into the liquid tray, DO NOT OVERFILL.
When the container is full, lower the housing and tighten the screws.
Attach the hanging bracket with the included tightening and metal screws.
Attach the M8 safety ring. This hooked safety ring can double insure the machine from falling down when
installed at high positions.
The B-200 Bubble machine can now be positioned in the desired location. Be careful to keep the
machine even while moving and installing otherwise liquid may spill out of the liquid tray. This is
particularly important when the mounting bracket is used to suspend the B-200.
Once the machine is securely positioned and a final check is made to insure that no liquid has leaked,
connect the power cord to the electrical supply. If there is any leakage or moisture on the machine, the
ANTARI Bubble Machine
2