Faults - Aerial WT 230 Bedienungsanleitung

Faults

Problem
Low or no
dehumidifying
performance
Device is out of
operation. Fan and
compressor do not
work.
Unexpectedly long
drying time
Possible cause
The air filter is severely
soiled. Air intake of indoor
air laundry dryer is too low.
Indoor air laundry dryer
switched off
Indoor air laundry dryer
without power supply
The indoor air laundry
dryer is not correctly
dimensioned for the
application.
There is a lot of humidity in
the walls, the floor etc.
49
Remedial action
Clean the filter (page 34, Fig.1,
item 1) or insert a new one.
Check the filter before each use.
Use only original air filters, since
unsuitable air filters will impair the
air flow.
Switch the indoor air laundry dryer
on (s. page 34, Fig.1, item 6).
Have the power cable, the plug
connection, the plug socket and
the building fusing checked by an
expert.
The air exchange rate, the
number of persons in the room,
the quantity of wet clothes and
any open water surfaces are
decisive for the humidity load of
the room. Ask your specialised
dealer to calculate the capacity
required for your application.
In this case the indoor air laundry
dryer will need some time to
remove the water and achieve an
acceptable value in the room.