Commissioning - Aerial WT 230 Bedienungsanleitung

Commissioning

To commission the indoor air laundry dryer proceed as follows:
1. Mount the indoor air laundry dryer, see page 35.
2. Make sure that the indoor air laundry dryer is connected, see page 35.
3. Make sure that the drain hose has been fitted correctly and is laid into a drain (see
section "Installation of condensate drain hose", from page 41).
For drying and keeping rooms with wood furnishing or paintings,
antiques etc. dry, a minimum moisture of 55 – 60% must be observed.
For living space, climate conditions of 20 – 25 °C and 50 – 60% relative
humidity are recommended.
In case of doubt please contact your technical advisor.
4. Switch on the indoor air laundry dryer via the On/Off switch (s. page 34, Fig.1,
item 6). The following indication appears in the display:
5. Select a program or drying mode on the operating panel.
In addition you can steer the drying air manually to different directions
via the pivotable baffle plates.
For detailed information concerning operation of the indoor air laundry
dryer please refer to the chapter Operation, page 44.
d
Ready
57%
43