Horizon Hobby HANGAR 9 Valiant 10cc Bedienungsanleitung Seite 25

141. Use a drill and 11/64-inch (5mm) drill bit to enlarge the
holes to mount the engine.
142. Use a ruler and felt-tipped pen to extend the lines on the
motor box.
143. Align the X-mount on the lines from the previous step.
Use a felt-tipped pen to mark the locations for the
mounting positions.
144. Use a drill and 11/64-inch (5mm) drill bit to enlarge the
holes to mount the engine.
145. Attach the motor mount to the fi rewall using four M4 x
15 socket head cap screws, four M4 nuts and eight M4
washers. Make sure to use threadlock on all hardware to
prevent them from vibrating loose.
Valiant 10cc
™
141.
142.
143.
144.
145.
146. The motor shaft must be repositioned to allow the
installation of the propeller adapter. Make sure not to
damage the motor when repositioning the shaft.
147. Attach the X-mount to the motor. Use a #2 Phillips
screwdriver to tighten the screws attaching the mount to
the motor.
148. Attach the propeller adapter to the motor. Use a 2.5mm
hex wrench screwdriver to tighten the screws attaching
the adapter to the motor.
149. Attach the motor to the motor box using the hardware
provided with the motor.
150. Use medium CA to glue a balsa block under the battery
tray inside the fuselage.
25
146.
147.
148.
149.
150.
EN