What If There Are Problems; Disposal; Technical Specifications - Beurer LB 55 Gebrauchsanweisung

10. What if there are problems?

Problem
No steam exiting
Appliance leaking
Delay in steam output
Red indicator [A] illu-
minated
If the problem persists, please contact customer service.

11. Disposal

For environmental reasons, do not dispose of the device in the household waste at the end of its useful life.
Dispose of the unit at a suitable local collection or recycling point. Dispose of the device in accor-
dance with EC Directive – WEEE (Waste Electrical and Electronic Equipment). If you have any ques-
tions, please contact the local authorities responsible for waste disposal.

12. Technical specifications

Rated output
Nominal voltage
Water tank volume
Evaporation rate
Overheating protection
Safeguard against
running dry
Switching
Weight
Dimensions (W / H / D)
Connection
Cause
Appliance not connected to power.
Water tank [8] empty.
Water tank [8] not fitted correctly.
Water tank [8] leaking.
Water tank [8] not shut properly.
Steam tower [3] not installed or not
installed correctly.
Very cold water in tank.
Appliance heavily scaled.
Water tank [8] empty.
Valve on tank catch [9] is covered with dirt. Clean the valve.
Appliance heavily scaled.
Water tank [8] not shut properly.
Water tank [8] not fitted correctly.
365W
230V / 50Hz
approx. 6 litres
Level I: approx. 200 ml/h
Level II: approx. 400 ml/h
Through thermostat
If there is not enough water in the heater unit, the appliance switches off auto-
matically. The appliance has a sensor which detects the water level.
2-stage
approx. 3.0 kg
310 / 230 / 350 mm
Fixed cable, approx. 1.4 m in length
Remedy
Insert the plug [11] into the mains
and switch on the appliance.
Replenish water.
Fit tank [8] properly.
Replace tank [8].
Fasten the catch [9] properly.
Install steam tower [3] properly.
Use warmer water.
Descale the appliance.
Replenish water.
Descale the appliance.
Close the catch [9] properly.
Fit tank [8] properly.
22