Herunterladen Inhalt Inhalt Diese Seite drucken

Control Panel; Initial Use; Filling The Tank - Beurer LB 55 Gebrauchsanweisung

Vorschau ausblenden Andere Handbücher für LB 55:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1

Control panel

A
Red indicator illuminated when
water tank is empty
B
Green indicator illuminated when
air humidifier is switched on
C
Steam button for regulating humidity
• Button depressed: approx. 400 ml/h (maximum
steam)
• Button released: approx. 200 ml/h (minimum steam)
D
ON/OFF button for switching
air humidifier on and off
• Button depressed: Appliance is switched on
• Button released: Appliance is switched off

6. Initial use

• Open the cardboard packaging.
• Now remove all plastic films.
• Check the device, mains plug and cable for damage.
Clean before using for the first time
For reasons of hygiene, we recommend rinsing the air humidifier, water tank and pad [4] thoroughly with
cold water before using for the first time. Then proceed as described in the "Cleaning the device" section of
chapter 8 "Cleaning and storage".

Filling the tank

Fill the tank when putting the appliance into operation for the first time or if the red indicator [A] is illuminated,
indicating that the water level is too low.
IMPORTANT
• Only ever use fresh tap water to fill the tank [8].
• Never put any additives into the water.
• Make sure that the tank catch [9] with seal on the base of the water tank [8] is tightly fastened before
putting the appliance into operation.
• Remove the cover [2] from the air humidifier.
• Pull the water tank [8] out of the air humidifier using the handles [7]. Unscrew the tank catch [9] from
the tank [8].
• Rinse out the water tank [8] with clean water.
• Fill the water tank [8] with cold tap water.
• Screw the tank catch [9] onto the water tank [8]. Place the water tank [8] in the air humidifier.
• Place the cover [2] on top of the air humidifier.
Air humidifier placement
Caution
Place the appliance so that the steam nozzle [1] is not pointing directly at a wall. The exiting moisture might
otherwise cause damage to walls, particularly to wallpaper.
• Place the air humidifier on a firm, even, water-resistant surface.
• Position the mains cable [11] so that the appliance cannot be knocked over.
A
B
18
I
C
II
D

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis