Battery Installation; Connecting To Power - Roadstar HIF-1902HP Bedienungsanleitung

3 English
46. RANDOM BUTTON: in cd/usb mode, press to active random function.
47. DELETE BUTTON
48. PROGRAM: in CD/USB mode, press to active programming function.

BATTERY INSTALLATION

The infra-red transmitter requires 2 pcs CR-2025 size battery for operation.

CONNECTING TO POWER

Before switching on make sure that the voltage of your electricity supply is the same as that
indicated on the rating plate.
For your own safety read the following instructions carefully before attempting to connect this
unit to the mains.
Press the POWER button during 1 second to turn ON the unit. Press and hold the POWER
button during 3 seconds to turn OFF the unit. When no sound is produced, the unit will switch
OFF automatically after 15 minutes.
MAINS (AC) OPERATION
This unit is designed to operate on AC 110-240V 50Hz current only. Connecting it to other po-
wer sources may damage the unit.
Caution: to prevent electric shock disconnect from the mains before removing cover.
No user serviceable parts inside. Refer servicing to qualified service personnel.
Remove the stereo carefully from the box, retaining the packaging for future use. Connect the
plug to a mains power inlet 110 - 240V AC ~ 50 Hz.
MW/FM TUNER
Operation
1. Switch ON the Power Switch (15). The red Power Indicator (17) will light up.
2. Select the desired frequency band with the Band Selector (14) for FM or (12) for MW band.
3. Tune to the desired radio station by turning the Tuning control (21).
Antenna
For FM reception there is a built-in FM antenna wire (28) at the rear of the unit. Move the

wire around to obtain the best reception.
 For MW reception the signals are picked up through a built-in ferrite antenna. Your may ha-
ve to orient the unit to obtain the best reception.
FM & FM-Stereo Reception
 Stereo reception is possible when the tuned FM station is broadcasting in stereo.
When in FM Stereo mode and the station is broadscasting in Stereo, the STEREO indicator

(19) lights up.
TURNTABLE OPERATION
VERY IMPORTANT!
To prevent damages from transportation, a transit screw is located at the upper right side of
the turntable platform. Before start playing, use a screwdriver and turn the transit screw in
clockwise direction (screw going down) completely. In case of transportation, remember to
clock again this screw in counter-clockwise direction to prevent damages.
Preparation
1. Open the Record Player Cover.