Single Standing Seam - Freund SEAMING PRO Gebrauchsanweisung

EN USER MANUAL

14. SINGLE STANDING SEAM

Before producing the single standing seam, it
must be ensured that the machine can enter the
panels. If this is not possible, the panel must be
pre-seamed to the length of the machine with a
squareseam folder.
To make the single standing seam, the tension
lever must be opened to remove the rear form
rollers C and D. These positions remain empty.
For the seaming process, the tension lever must
be closed again. Make sure that the cordless
screwdriver is not ready for operation when chan-
ging the rollers.
Subject to technical changes. Please observe the safety instructions.
31
WWW.FREUND-CIE.COM