Deuba monzana DBES001 Bedienungsanleitung Seite 14

4. The winch's internal mechanism
permanently lubricated. Do not open the
housing. However, if the winch is submerged,
it should be opened, dried, and re-lubricated
prevent corrosion.
Wire Rope Replacement
1.
2.
inside of the drum.
3.
assembly.
WARNING! Do not replace with inferior Wire
Rope.
.
4. Retract Wire Rope onto Wire Rope drum
being careful not to allow kinking. Refer to
Preparing the Wire Rope on page 25.
5.
is
www.Deuba24online.de
Problem Possible Causes
Motor overheats. 1. Incorrect power cords.
2.
long.
Motor does 1.
not turn on. 2.
3.
charging.
4.
5. Remote damaged.
6.
7. Water has entered motor.
8. Internal damage or wear.
Motor runs but Clutch not engaged.
Wire Rope drum
does not turn.
Motor runs 1.
slowly or without voltage.
normal power. 2.
3. Incorrect power cords.
Motor runs in one 1.
2. Remote damaged.
the tool. Disconnect power supply before service.
www.De uba24o nline. de
26 27
1. Use only supplied power cords.
2. Allow winch to cool down periodically.
1.
2.
3.
4. Tap solenoid to loosen contacts. Apply 12
volts to coil terminals directly. A clicking
5. Replace Remote.
6. Check for voltage at armature port with
Switch pressed. If voltage is present,
replace motor.
7. Allow to drain and dry. Run in short bursts
8. Have technician service winch.
Move the Clutch Handle to the Engaged
needs to check and repair.
1.
vehicle motor running.
2.
3. Use only supplied power cords.
1. Tap solenoid to loosen contacts. Repair or
replace solenoid.
2. Replace Remote.