Deuba monzana DBES001 Bedienungsanleitung Seite 10

WICHTIGE SICHERHEITSINFORMATION
are factors which cannot be built into this
product, but must be supplied by the operator.
1. Do not wear loose clothing or jewelry, as
they can be caught in moving parts. Non-skid
hair covering to contain long hair.
2. Wear CE-approved safety goggles and heavy-
3.
of fuel lines, brake lines, electrical wires, gas
tanks or any other component which could be
damaged during drilling.
4.
support winch and load.
5. Use supplied power cords and wire rope listed
in manual only. Do not use thinner/longer
6. Do not route electrical cables near sharp
edges or parts that will move or become hot.
7.
can accumulate and then explode when
8. Only connect to a clean, corrosion free
9. Do not lean over or come in contact with
10. Remove all metal jewelry before working near
11.
12.
13. Install winch and fairlead in underwind
Read the ENTIRE IMPORTANT SAFETY
manual including all text under subheadings
therein before set up or use of this product.
1. The plate must be rated to at least the winch's
capacity.
2. Align the winch perpendicular to center line
Compare the dimensions of the marked holes
to Figure A.
www.Deuba24online.de
8.11in./206mm
11.22in./285mm
Figure A: Winch Dimensions
3.
surface has no hidden components or
structural pieces that will be damaged.
NOTE: This winch can generate extreme
rated capacity without damage or weakening.
Steel reinforcement plates may be needed
4. Drill holes appropriate for the hardware at the
5. Install the winch using hardware described
1.
• Winch components are close enough to each
other to allow wires to be routed properly.
•
with.
• Vehicle components are not damaged by
drilling or driving screws.
www.De uba24o nline. de
18 19
2.88 in./ • Winch components will not be damaged by
73mm
2.
be.
3.
hidden components or structural pieces that
will be damaged before drilling
2*Ø0.33in./8.5mm
4.
5.
Wiring
WARNING
1.97in./
TO PREVENT SERIOUS INJURY FROM EXPLOSION
50mm
DUE TO SPARKING
CONNECTION:
TO PREVENT SERIOUS INJURY FROM LEAKING
BATTERY ACID:
1. Plan a route for the wiring from the point of the
vehicle where the winch will be mounted, or
out of the way of moving parts, road debris, or
or maintenance of the vehicle. For example,
you may wish to route the wires under the
cable, fuel line, or any other components
which may create damage the wiring through
AT THE BATTERY