Deuba monzana DBES001 Bedienungsanleitung Seite 11

2. If you drill through the bumper or any part of
the body to route the wires, be sure to install a
rubber grommet in the hole to prevent fraying
of the wires at that point.
3.
and from the switch to the Winch, following
4.
5.
to the Terminal of the Winch Motor. Red cable
Winch Motor, and the black cable connect to
Note:
the Switch.
Winch
Black
Black
Red
Red
Switch
Preparing the Wire Rope
1. The wire rope must be properly coiled under
tension to be able to support a load without
damage.
2. Uncoil the wire rope, except for 5 full wraps.
3. Recoil the wire rope back into the winch under
at least 500 lb. of tension.
1.
whether the clutch is engaged or not.
2.
• Pull clutch knob out.
• Turn it 90° while it is pulled out, then release
it.
If the pin rests
in the groove in
Drum
the drum
End
the clutch is
engaged.
If the pin rests
on top of the end
Drum
of the drum the
End
clutch is released.
www.Deuba24online.de
1. Do not exceed load capacity. Be aware of
dynamic loading! Sudden load movement
failure.
2. Wear CE-approved safety goggles and heavy-
3. Do not disengage clutch under load. Engage
4.
try to guide wire rope.
5.
may be caught and get pulled into fairlead or
drum. Use included strap to hold hook instead.
Note: If a winch is to be used to pull a vehicle,
at least twice the vehicle's weight.
6.
7.
8. Put the vehicle's transmission in Neutral.
9. If the vehicle where the winch is mounted
is not supposed to be moved, engage the
emergency brake and block the wheels using
wheel chocks.
10. To pull out the wire rope, move the Clutch
Hook Strap over the hook, then pull on the
Hook Strap to pull out the wire rope.
WARNING!
wire rope on the drum.
www.De uba24o nline. de
20 21
11. Hook onto the object using a pulling point,
tow strap, tree strap, or chain. See Figure D.
Figure D: Using a strap anchor point.
Do not wrap the wire rope around the object
and hook onto the wire rope itself.
This can damage the object being pulled, and
kink or fray the wire rope.
12.
hook and the hook's safety clasp must be fully
closed. See Figure H.
WARNING! Do not allow anyone to stand
near the wire rope, or in line with the wire
rope behind the winch while it is under
power. If the wire rope should slip or break,
it can suddenly whip back towards the winch,
causing a hazard for anyone in the area. Stand
well to the side while winching.
WARNING! TO PREVENT SERIOUS INJURY
AND DEATH:
Operate the winch only while you have a
view becomes obstructed.