Troubleshooting - eeese Axel 2538 Benutzerhandbuch

13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
8.

Troubleshooting

Before contacting technical Support, check the following.
PROBLEM
Unit not working
Display is
normal, but no
dehumidification
IMPORTANT!
Please do not try to repair the dehumidifier by yourself to avoid any risk.
MV-2538-2540-2542-09-2020 . eeese-aircare.com © All rights reserved by eeese air care ApS
P6 Evaporation coil temperature sensor failure
P7
P8
P9
PA
F1 Compressor drive module or related wiring failure
F2
F3
F4
F5
F6
F7
F8
F9
FA
POSSIBLE CAUSE
The power is not connected.
Burned fuse.
The breaker is off.
The humidty set is too low.
3 minutes start delay.
Ambient humidity sensor failure
Cooling plate sensor failure
Current sensor failure
Restart memory failure
PFC module failure
Compressor start failure
Compressor running failure
Inverter board over current protection
Inverter board overheat protection
Over current protection
Radiator high temperature protection
DC fan fault
PFC module over current protection
SOLUTION
Plug into the socket.
Check and change the fuse.
Check and turn on the breaker.
Set proper humidity percentage.
Wait patiently.
UK
69