quadient AS-850 Kurzanleitung

AS-850 Quick start Guide
Main menu
• Print Image: Select, Import or Delete an
1
image.
• Printer Setup: Set Printer parameters to
adjust the Printer.
• Tools: Run Ink Cost Estimator, Ink Status,
Diagnostic tests, Network, and Screen
Calibration.
• Print Data: Display information about the
job printing.
•
Test Print: Print a test page using current
adjustments and print parameters.
• Info: Display information about the Printer.
Install inkjet cartridges
To install inkjet cartridges,
open latch lever fully, place
cartridge into pen stall and
push until it bottoms out in
pen stall. Close latch lever.
For additional information on your adressing system please
consult the user guide: kb.quadient.com/as850_ug_en
1 - Set Up the Media Transport System
Media Side Guide and Transport Belt Adjustment
1. Loosen the Side Guide securing
knobs and slide the Media Side
(a)
Guides apart. Center the Me-
(b)
dia Hold-Down Strap over the
wide, center transport belt.
a
b
Slide one piece of media, cente-
3.
red, in the entrance end of the
printer.
3 - Media Thickness Adjustment
To adjust media thickness:
1. Turn Media Thickness Knob (a) fully
2. Slide a piece of media
(b) under
Printheads
3. Adjust the Media Thickness Knob (a)
counter-clockwise until the bottom
of the Print Unit just touches the
media. Then remove the media.
4. Position the Exit Pressure Roller
Assembly so it rides on the media.
5. Turn Printer ON.
2 - Position Print Units
1.
2.
Reposition the Outer Trans-
2.
port Belts to fit the width
of your media.
3.
Use Media Control Guide & Exit Pressure Roller Assembly
The Printer is shipped with two accessories you can use to help
improve how Media travels through the Printer:
• Media Control Guide
• Exit Pressure Roller Assembly
Position the Media Hold-
4.
Down Strap (2) to help hold
the media down.
b
Install and position the Media
Control Guide
the Media, if:
• Media is lifting and touching
• Media is catching or skewing
• Media is catching or skewing
Install and position the Exit
Pressure Roller Assembly (c), to
contact the Media, if:
• Media is turning or skewing as
b
a
• Printed image is distorted, due
Loosen locking screw(s) (a).
Position Print Unit(s) as needed
to achieve desired print locations
on Media being fed.
Secure locking screw(s) (a).
(b)
(c)
(b) to hold down
or smearing the wet image
printed by the first Print Unit.
as it travels under the middle
Print Unit.
as it enters under the last Print
Unit.
it exits Printer.
to Media hesitation or skew.
a
c
b
b
c
c
b
A0136346/A - 29/10/2020
1/4