Using The Appliance - Philips Vacuum Plus BT7085 Bedienungsanleitung

Using the appliance

Display indications (BT7085/QT4070 only)
The display is activated when you press the on/of button and when you
turn the adjustment ring.
During trimming, the display provides the following information:
-
, '-' when no comb is attached to the appliance.
, The selected hair length (i.e. the remaining hair length after
trimming) in millimetres.
, The remaining charge level.
, Travel lock indicator if the appliance is locked (see section 'Travel
lock' in this chapter).
, 'E' if the cutting unit is blocked.
Beard trimming
Always comb your beard or moustache with a ine comb before you
start trimming.
Trimming with trimming comb
The hair length settings are indicated in millimetres on the display of the
appliance. The settings correspond to the remaining hair length after cutting.
The trimming comb cuts hair to a length of 1-18mm.
If you trim for the irst time, start with the maximum hair length setting
(18mm).
1 Slide the trimming comb onto the appliance.
2 Turn the adjustment ring (Precision Zoom Lock
hair length setting.
The display shows the selected hair length.
,
3 Switch on the appliance.
Note: During trimming, you can use the turbo function for extra suction power
and trimming speed (see section 'Turbo function' below).
ENGLISH
7
TM ) to the desired