Adjusting The Machine; Mounting Accessories - Ferm BJM1009 Bersetzung Der Originalbetriebsanleitung

dangerous to insert the plug of a loose cable in
the wall outlet.
Using extension cables
Only use an approved extension cable suitable
for the power input of the machine. The minimum
conductor size is 1.5 mm2. When using a cable
reel always unwind the reel completely.

3. ADJUSTING THE MACHINE

Adjusting the cutting depth
Fig.B
• M ove the motor housing (3) as far as possible
backwards.
• S et the cutting depth by turning the cutting
depth adjustment knob (9).
• T he markings on the depth adjustment knob
(9) correspond to the biscuit dowel size being
used (16).
• Y ou can fine adjust the cutting depth setting by
turning the depth fine adjustment screw (10).
• M ove the motor base forwards and check if
depth fine adjustment screw (10) will fall in the
notch of the adjustment knob.
The following table shows the relationship of
the markings on the adjustment knob to cutting
depth, thickness of material and associated
biscuit dowel.
Marking Thickness
of material
0 8-12 mm
10 12-15 mm
20 > 15 mm
Max. -
Adjusting the cutting angle
Fig. A + G
The cutting angle can be set the following way:
• R elease the angle adjustment knob (6) by
turning it anti-clockwise
• T he set angle is shown on the scale (21) below
the knob (6)
• A fter setting to the right angle, tighten the
knob (6) again by turning it clockwise.
Downloaded from www.Manualslib.com
Biscuit Cutting
Dowel depth in mm
No. 0 8.0
No. 10 10.0
No. 20 12.3
- 14.0
manuals search engine
Adjusting the height to match material
thickness
Fig. B
The correct height can be set the following way:
• R elease the height adjustment knob (8) by
turning it anti-clockwise
• T he set height is shown by the scale and the
arrow (22).
• A fter setting to the right height, tighten the
knob (8) again by turning it clockwise.
The height must correspond to half of the material
thickness of the working piece, the groove for the
biscuit dowel must always be in the middle of the
working piece.

4. MOUNTING ACCESSORIES

Prior to mounting an accessory always
unplug the tool.
How to change the saw blade
Your machine is delivered with the saw
blade already assembled on the machine
Fig. C & D
• P ut the machine in upside-down position and
remove the 4 screws on the bottom plate by
using a screw driver (not included)
• R emove the bottom plate (20)
• P ress the spindle lock (5) and turn the spindle
until it engages in the lock. Keep the spindle
lock pressed during this procedure.
• R emove the flange nut (17) from the spindle
by using the spanner (14) and turn it
counterclockwise.
• P osition the saw blade (18) on the flange (17).
• B e aware that the arrow on the sawblade
indicates the same direction as the arrow on
the inside of the housing.
• P lace the flange nut (17) on the spindle and
tighten it with the wrench.
• T ake care the flange nut (17) will be placed the
correct way: The collar side must fit inside the
saw blade bore, the flat side must be pointing
upwards.
• R elease the spindle lock and check that the
spindle is unlocked by rotating it.
7