National Instruments SCXI Serie Schnellstartanleitung Seite 3

Step 2. Verify the Components
Make sure you have the SCXI system components shown in Figure 1 and the following items:
• NI-DAQ 7.x or later software and documentation
• At least one of the following software packages and documentation:
– LabVIEW
– LabWindows
– Visual C++
– Visual Basic
• SCXI product manuals
• 1/8 in. flathead screwdriver
• Numbers 1 and 2 Phillips screwdrivers
• Wire insulation strippers
• Long nose pliers
1
1 Terminal Block or TBX Accessories (Optional)
2 PXI Module
3 SCXI Modules
4 PXI/SCXI Combination Chassis with Controller
Step 3. Set Up the Chassis
Caution Refer to the Read Me First: Safety and Radio-Frequency Interference document packaged
with your chassis before removing equipment covers or connecting or disconnecting any signal
wires. Follow proper ESD precautions to ensure you are grounded before installing the hardware.
SCXI Chassis
1. Power off and unplug the chassis.
2. Set the chassis address if your chassis is addressable. Some older chassis are not addressable.
• If the chassis has address switches, set the positions to off. In Figure 2, all switches are shown
in the off position.
SCXI Quick Start Guide
™ ™
/CVI
SCX
I
Or 1140
2 3
Or
8 9
Figure 1. SCXI System Components
®
PO WE
R
Or
RE SE
T
5
4
3
2
1
SC
MAIN XI
FRAM E
4 5
7
Or
10 11
5 SCXI Chassis
6 Chassis Power Cord
7 For SCXI Chassis Only
8 Chassis Adapter Assembly
2
6
12
9 DAQ Device
10 USB Cable
11 SCXI USB Device
12 Personal Computer
ni.com