National Instruments SCXI Serie Schnellstartanleitung Seite 15

19. If you need to change any chassis settings, click the Chassis tab.
20. Click OK to accept and save the settings for this chassis.
A message at the top of the SCXI Chassis Configuration window displays the status of the
configuration. You cannot save the chassis configuration if an error appears until you finish
entering module information. If a warning appears, you can save the configuration, but NI
recommends that you correct the source of the warning first.
21. For IEEE 1451.4 transducer electronic data sheet (TEDS) sensors and accessories, configure the
device and add the accessory as previously described. To configure TEDS sensors cabled directly
to a device, in MAX, right-click the module under Devices and Interfaces and select Configure
TEDS. Click Scan for HW TEDS in the configuration window.
Add Modules to an Existing System
Complete the following steps:
1. Expand Devices and Interfaces»NI-DAQmx Devices. If you are using a remote RT target, expand
Remote Systems, find and expand your target, and right-click Devices and Interfaces»
NI-DAQmx Devices.
2. Click the chassis to display a list of slots.
3. Right-click an empty slot and select Insert. The SCXI Chassis Configuration window opens.
4. Click Auto-Detect All Modules and Yes.
5. Starting with step 6 of the previous section, follow the instructions to configure the module.
6. Test the chassis, as described in
SCXI Quick Start Guide
19
Step 13. Test the
14
Chassis.
ni.com