Fein ALG80 Originalbetriebsanleitung Seite 12

en
12
LED indicator
ALG80BC:
Continuous blue light
Continuous yellow light
Continuous red light
The charge indication of charger and battery may temporarily vary for technical reasons.
Meaning
The battery charger is ready for operation; mains voltage is given.
®
The Bluetooth module is coupled with a mobile device.
Note:
®
The Bluetooth module automatically switches to energy saving mode after a
longer period of inactivity. By inserting a Li-ion battery, the Bluetooth
activated again.
The battery temperature is not within the charge-temperature range of 5 °C to
+45 °C. The rapid charging starts as soon as the battery reaches the allowable
charging-temperature range.
Charging not possible due to the following possible reasons:
– Contacts contaminated. Improvement measure: Clean the contacts by inserting
and removing the battery several times.
– The battery is defective. Improvement measure: Replace the battery!
Charging procedure
Continuous green light
flashing LED
Rapid charging starts.
The rapid charging is active.
Charge condition of battery ≤ 25%
The rapid charging is active.
Charge condition of battery ≤ 50%
The rapid charging is active.
Charge condition of battery ≤ 75%
Rapid charging is over.
Charge condition of battery ≥ 75%
LED continuously OFF while battery is attached on charger:
Rapid charging is over.
Battery fully charged for more than 1 hour on the charger.
®
module is