D) Programming Wireless Sockets To The Remote Control - Sygonix 2266217 Bedienungsanleitung

• Using the three upper channel buttons in the right column,
you can deactivate channels 1 to 3 individually. The power
LED (6) of the wireless socket that has been switched off
goes out.
Using the lower ALL ON button (3) in the left column, you can
•
switch channels 1 to 3 on simultaneously. The power LEDs (6)
of the wireless sockets that have been switched on light up.
Using the ALL OFF button (3) in the left column, you can
•
switch channels 1 to 3 off simultaneously. The power LED (6)
of the wireless sockets that have been switched off go out.
d) Programming wireless sockets to the
remote control
1. After connecting a wireless socket to the power supply, the
power LED (6) flashes. This indicates that the wireless socket
is ready for programming with the remote control.
2. Select a pair of channel buttons (2) (left ON, right OFF) to
which you wish to assign switching of the wireless socket. It
is best to start with the button in the upper left of the remote
control. Repeat the assignment in a uniform system for each
switch group. This simplifies correct and precise switching
and avoids confusion, especially when controlling more than
three wireless sockets with the remote control.
3. Press and hold the ON button for approx. 5 seconds. If the
power LED of the wireless socket is permanently lit, pairing
with this channel button pair was successful. You can now
switch the programmed wireless socket on or off with the two
channel buttons ON and OFF.
42