Operation - AEG PMR Voxtel R100 Handbuch

4

OPERATION

4.1 Turning the unit on/off
To turn on:
Press and hold the power button
>A special "beep" sound will be heard. The LCD screen will display the current channel.
To switch off:
Press and hold the power button
>A special "beep" sound will be heard and the LCD screen will turn blank.
4.2 Adjusting the speaker volume
There are 8 volume levels, the current speaker volume level is displayed on the LCD screen.
To adjust the speaker volume level:
Press the up button
>The LCD screen will display the speaker volume icon bars ascending, or descending
respectively.
4.3 Receiving a call
The unit is continuously in receive mode when the unit is turned on and not transmitting.
When a signal is received on the current channel, the receive signal icon
displayed on the LCD screen.
4.4 Transmitting (sending)
Press and hold the PTT (Push to Talk) button to transmit your voice.
>The transmit signal icon
Hold the unit in a vertical position with the microphone 5 cm away from the mouth. While
holding the PTT button, speak into the microphone in a normal tone of voice.
Release the PTT button when you have finished transmitting.
Important:
In order for other people to receive your transmission, they must also be on the same
channel that you are currently using. Refer to the „4.6 Changing channels" for more
information.
When the PTT and/or call buttons
any transmissions.
4.5 Roger beep
The roger beep is a tone which is automatically transmitted whenever the PTT button is
released. This alerts the receiving party that you have ended the transmission, and you are
now in receive mode.
.
.
to increase or press down button
will display on the LCD screen.
are continuously pressed, your PMR cannot receive
to decrease.
5
will be