Installation - AEG PMR Voxtel R100 Handbuch

4
Displayed when key lock function is activated.
Displayed when transmitting a signal.
Displayed when receiving a signal.
Displayed the full volume level.
3

INSTALLATION

3.1 Removing the belt clip
Pull the belt clip latch away from the PMR.
While pulling the belt clip latch, push up the
belt clip as shown.
3.2 Installing the belt clip
Slide the belt clip into the slot as shown.
>A "click" indicates the belt clip is locked into
its position.
3.3 Installing the batteries (see P3)
Slide down the battery compartment cover.
Insert 3 x AAA batteries. Position the batteries
according to the polarity marking
battery compartment.
Replace the battery cover.
Notes:
The PMR units have a built-in power saver (PS) for maximum battery life, but when not in
use, turn the units off to save battery power.
Remove the batteries if the units will not be used for a long period of time.
Do not mix battery types in the PMR unit.
Disposed of used batteries safety at a recycling centre.
Don't leave dead batteries in your PMR units. They might leak and cause damage for the
unit and surroundings.
3.4 Battery level
The battery icon is located in the left corner of the LCD panel. This battery icon will displayed
when low battery status. These indicate that the battery level reaches its minimum level, at
this stage the unit will emit two beep tones and then it will automatically turn off the power.
on the
Belt clip latch