Product Specifications; Troubleshooting - Ryobi RY36BI300A Bedienungsanleitung

PRODUCT SPECIFICATIONS

Battery Inverter
Model: RY36BI300A
Supply: 36 V DC, 12.5 A MAX, 450 W MAX
Output: 230 V AC, 50 Hz, 300 W
Type A USB: 5 V DC max 3 A / 9 V DC
max 2 A / 12 V DC max 1.5 A
Type C USB: 5 V DC max 2 A / 9 V DC max
2 A / 12 V DC max 2 A / 20 V DC max 2 A
*The USB ports share internal circuitry.
If two USB ports are in use at the same
time, the two USB ports supply 5 V
output only.
Dimensions: 140 mm x 75 mm x 80 mm
Weight: 300 g
Compatible battery packs (not included):
BPL36***, RY36B***
POWER BUTTON LED FUNCTIONS
LED indicator Status
Green The product is on.
Flashing red The product is
overloaded.
Red The product is
overheated.
Flashing yellow The battery charge is low. Remove and charge the battery.
Flashing red (3x) The battery charge is
insuffi cient.
4
Original Instructions

Troubleshooting

1. Press the power/light button to
remove the lock state. The LED
indicator turns off .
2. Disconnect all devices. Make
sure that the battery is suffi ciently
charged.
3. Press the power/light button to
turn on the AC socket.
4. Reconnect all devices. If the LED
indicator fl ashes red again, the
devices exceed the capacity of
the product.
1. Disconnect all devices. Allow the
product to cool down until the
LED indicator fl ashes red.
2. Briefl y press the power/light
button to reset the product. When
the LED indicator turns green,
reconnect the devices.
Remove and charge the battery.