Channel Selection - AUDIOropa Xepton-NX TX Bedienungsanleitung

How to use
2.2 Power ON / OFF
Slide the ON/OFF switch upwards to switch the
device on. The LC-display will light up and the
currently selected group number is shown.
After 8 seconds the display goes out. It lights
up again when an entry is made and goes out
again after 8 seconds.
To switch the device off after use: Slide the ON/
OFF switch back to the lower position.

2.3 Channel selection

Switch the device on and press the MODE-button
for 3 seconds.
The symbol »CH« in the display will blink. Select
a channel of 0-7 by pressing the » « and » «
 
buttons. After the selection, wait for 3 seconds to
set the selected channel number.
Please note:
There should only be one active TX transmitter
within a channel number! Additional activated
transmitters with the same channel number will
cause interference in the sound quality.
Should a simultaneous transmission of several
transmitters be desired, please consider using
TRX transceivers instead.
Transmitters and receivers must be set to the
same channel number if they are to communicate
with each other.
English 15