EcoDim ECO-DIM.06 Handbuch Seite 4

Operation
1) Min. Bright Adjustment.
To ensure the dimmer to work optimally, you can adjust the lights brightness at min. from the dimmer.
Min. adjustment
When the light is on and at the
previous set min. level,
Anti-clockwise the VR to
decrease or clockwise to increase
the brightness at the min. level to
your preference, and avoid
ickering as well.
2) Factory Reset
Step 1. Press the reset button
for 5s.
Please note:
This procedure should only be used when the primary controller is inoperable.
The entire con guration is reset after the device is reset or removed from the network.
Reset
Min
Indicator
Reset
Min Step 2. When the Indicator stay in
Indicator
Red for 10s, reset nished.
3) Inclusion to the Zigbee Network
Step 1. Remove the device from a previous Zigbee network if it has already been added to one, otherwise
pairing mode will be fail.
Step 2. From your Zigbee Controller interface, choose to add lighting and enter the pairing mode.
Step 3. Double Press the reset
button.
4) Exclusion from the Zigbee Network
Method 1. From your Zigbee hub interface, choose to delete or reset the device as instructed.
Method 2. Remove from the Device, see below instructions.
Step 1. Press the reset button for 3
times.
Reset
Min Step 4. The indicator will start blinking
Indicator
blue and will stay solid for 10s when
pairing succeeds. Timeout 15mins.
Reset
Min
Step 2. The indicator will start blinking
Indicator
purple and will stay solid for 10s when
removing is completed. Timeout 3mins.